Roof Ridge Length Calculator

Estimate roof ridge length based on building length, width, and roof design.

Result

Enter values and calculate to see results here.

Roof Ridge Length Calculator

The ridge is the horizontal line where roof planes meet at the top of a structure. Ridge length is needed for estimating ridge boards, ridge cap materials, ridge vents, and flashing details. This calculator provides a planning estimate based on building dimensions and roof design (gable, hip, or shed). Actual ridge length can vary with framing details, unequal pitches, and overhang treatments, so verify with drawings or field measurements before ordering or cutting.

For a simple gable roof, the ridge typically spans the building length. For a regular hip roof on a rectangular plan with equal slopes, hips at each end shorten the ridge—commonly approximated as building length minus building width. A shed roof has a single high edge rather than a central ridge between opposing slopes, but its top-edge length is often relevant for trim and waterproofing planning.

Formula

Adjusted Length = Building Length + 2 × End Overhang
Gable: Ridge = Adjusted Length
Hip (regular): Ridge = max(0, Adjusted Length − Building Width)
Shed: Top Edge ≈ Adjusted Length

These formulas assume regular geometry and equal slopes where applicable. End overhang extends the ridge/top edge when present. Irregular plans or unequal pitches require detailed layout rather than a simple subtraction.

Roof Type Summary

TypeTypical ridge behavior
GableFull-length ridge between two slopes.
HipShortened ridge with sloping hip ends.
ShedSingle high edge (no opposing-slope ridge).

For material takeoffs, add allowances for overlaps, end caps, and waste per manufacturer instructions. Complex roofs with multiple ridges should be calculated segment by segment.

Frequently Asked Questions

Why is a hip ridge shorter?

Hip slopes at each end replace part of the ridge, reducing its length on a regular rectangular plan.

Does this include overhang?

Yes, if you enter end overhang it is added to the building length.

Can I use this for L-shaped roofs?

Break the roof into simple sections and calculate ridges for each separately.

Is ridge cap length identical?

It is close, but include product overlaps, closures, and waste per instructions.

What about unequal pitches?

Unequal pitches change geometry; use detailed design/layout for accurate ridge location and length.

References

Disclaimer: This tool provides planning estimates only, not a contract, guarantee, engineering determination, or professional advice. Verify measurements, local code requirements, material specifications, and safety conditions with qualified professionals before purchase or work.