Roof Pitch Calculator

Convert rise and run into roof pitch ratio, degrees, and slope percentage.

Result

Enter values and calculate to see results here.

Roof Pitch Calculator

Roof pitch describes how steep a roof is and is one of the most important measurements in roofing design, estimation, and material selection. In North American practice, pitch is commonly expressed as inches of vertical rise per 12 inches of horizontal run (for example, 6:12). This Roof Pitch Calculator converts a measured rise and run into a standard pitch ratio, slope percentage, and angle in degrees, giving you multiple ways to communicate and apply the same slope information.

Understanding pitch helps you choose appropriate roofing materials, estimate surface area multipliers, plan drainage, and assess installation complexity and safety requirements. Low-slope and steep-slope roofs have different system requirements, and some materials are only suitable above certain minimum pitches. Always follow manufacturer instructions and local building codes for your specific roof assembly.

Formula

Pitch (per 12) = Rise × (12 / Run)
Slope (%) = (Rise / Run) × 100
Angle (°) = arctan(Rise / Run) × 180 / π
Slope Length = √(Rise² + Run²)

The ratio normalizes any rise/run measurement to a 12-inch run. Slope percentage expresses vertical change per 100 units horizontal. The angle is computed with the arctangent of rise over run. The slope length gives the diagonal distance per run segment, useful for rafter and area calculations.

Common Pitch References

PitchApprox. degreesNotes
2:129.46°Low slope; system selection is critical.
4:1218.43°Common moderate residential pitch.
6:1226.57°Moderately steep; good drainage.
9:1236.87°Steep; added safety considerations.
12:1245.00°Very steep; significant area increase.

How to Measure Safely

Rise and run can be measured from framing plans, in an attic, or at a gable end using safe methods. Avoid unnecessary roof access; working at height carries fall risk. If you must measure on a roof, use proper fall protection and follow applicable safety regulations. When in doubt, consult a qualified professional.

Why Pitch Matters

Pitch affects water shedding, snow behavior, material compatibility, ventilation design, and installation labor. It also changes the true surface area relative to footprint, which directly impacts material quantities and cost. Accurate pitch input improves every downstream roofing calculation.

Frequently Asked Questions

Is pitch the same as slope?

They describe steepness but are often expressed differently: pitch as rise per 12 (e.g., 6:12) and slope as a percentage or ratio. This tool shows both.

Can I enter inches or feet?

Yes, as long as rise and run use the same unit. The ratio and angle are unit-independent.

What pitch is considered low slope?

Definitions vary by code and manufacturer, but roofs below about 3:12 are often treated as low-slope with specific system requirements. Verify for your product and jurisdiction.

Does a steeper pitch cost more?

Often yes, due to increased surface area, material needs, and labor/safety complexity.

How accurate is a measurement from the ground?

Ground estimates can be rough. For ordering and construction, use verified measurements or professional assessment.

References

Disclaimer: This tool provides planning estimates only, not a contract, guarantee, engineering determination, or professional advice. Verify measurements, local code requirements, material specifications, and safety conditions with qualified professionals before purchase or work.