Roofing Felt Calculator
Asphalt-saturated roofing felt (often referred to as #15 or #30 felt) has long been used as an underlayment in steep-slope roofing systems. Calculating the number of rolls required depends on roof area, the gross coverage of each roll, and the overlap between courses. This Roofing Felt Calculator provides a planning estimate of rolls needed and total gross coverage so you can prepare purchasing lists and reduce the risk of running short during installation.
Traditional felt rolls come in common sizes (for example, a #15 roll covering roughly 400 sq ft or a #30 roll covering roughly 200 sq ft gross), but actual coverage varies by product and how it is installed. Laps at horizontal and vertical joints reduce net coverage. Local codes and manufacturer instructions specify required overlaps, number of layers, and where felt is appropriate versus synthetic or self-adhered underlayments.
Formula
Effective Factor ≈ 1 − (Overlap inches / 36)
Effective Coverage per Roll = Roll Coverage × Effective Factor
Rolls Required = ceil(Roof Area / Effective Coverage per Roll)
Total Gross Coverage = Rolls Required × Roll CoverageOverlap is approximated relative to a typical 36-inch course exposure to estimate net coverage loss. Dividing roof area by effective coverage per roll yields the roll count, rounded up. Total gross coverage reflects the full roll area purchased.
Common Felt Types
| Type | Typical gross coverage | Notes |
|---|---|---|
| #15 felt | ~400 sq ft/roll | Lighter; suitability depends on code and application. |
| #30 felt | ~200 sq ft/roll | Heavier; often specified where greater durability is needed. |
Verify whether felt is permitted for your roof covering and slope, and consider modern synthetic underlayments where appropriate. Proper fastening and lapping are essential for performance.
Frequently Asked Questions
Is #15 or #30 felt better?
It depends on the application, code, and manufacturer requirements. #30 is heavier and may be specified in certain conditions.
How much should I overlap felt?
Typical laps are often around 2–4 inches for headlaps and more for endlaps, but follow the product and local code requirements exactly.
Can felt get wet?
Felt can wrinkle or degrade if saturated. Install under suitable conditions and cover within recommended timeframes.
Does this include ice and water shield?
No. Self-adhered membranes for eaves and valleys are separate products and should be estimated independently.
Should I buy extra?
Rounding up is recommended to account for waste, tears, and detailing.