Roof Drainage Calculator

Estimate roof runoff and recommended drainage capacity from roof area, slope, rainfall intensity, and drain capacity.

Result

Enter values and calculate to see results here.

Roof Drainage Calculator

Effective roof drainage prevents ponding water, reduces structural load risks, and protects roof membranes and building interiors. Drainage design must account for roof area, slope, rainfall intensity, and the capacity of drains, scuppers, or gutters. This Roof Drainage Calculator estimates runoff rate and the number of drains/outlets needed based on your inputs. It is a planning estimate—low-slope roof drainage should be designed in accordance with applicable plumbing/building codes and, where appropriate, by qualified professionals.

Ponding on low-slope roofs can occur when drainage is inadequate or when deflection creates low points. Codes often require both primary and secondary (overflow) drainage systems to prevent catastrophic accumulation if primary drains are blocked. Slope, drain placement, and inlet sizing all affect real-world performance.

Formula

Runoff Coefficient (C) ≈ 0.90–0.95 for roof surfaces
Runoff (gpm) = 0.0104 × Area (sq ft) × Rainfall Intensity (in/hr) × C
Required Drains = ceil(Runoff / Drain Capacity)
Secondary/overflow drainage should be provided per code

The rational-method style estimate converts rainfall over the roof area to a flow rate, adjusted by a runoff coefficient. Dividing by the rated capacity of each drain yields a minimum count. This simplified approach does not replace hydraulic design for complex roofs.

Drainage Design Considerations

ItemWhy it matters
Positive slopeDirects water to drains; avoids ponding.
Overflow/scuppersProvides backup if primary drains clog.
Strainers/maintenanceKeeps inlets clear of debris.

Always follow local code requirements for roof drain sizing and overflow provisions. For large or complex roofs, consult an engineer or qualified designer.

Frequently Asked Questions

What rainfall intensity should I use?

Use the design storm intensity specified by local code or authoritative rainfall data for your location.

Does this include overflow drains?

No. The result estimates primary capacity needs; codes commonly require separate secondary/overflow drainage.

Why does ponding matter?

Ponding adds weight, can accelerate membrane deterioration, and may indicate inadequate slope or drainage.

Can gutters be used instead of internal drains?

It depends on roof type and design. Low-slope commercial roofs often use internal drains/scuppers; steep-slope roofs typically use gutters.

Is drain capacity the same for all products?

No. Capacity depends on drain size, head, and configuration—use manufacturer ratings.

References

Disclaimer: This tool provides planning estimates only, not a contract, guarantee, engineering determination, or professional advice. Verify measurements, local code requirements, material specifications, and safety conditions with qualified professionals before purchase or work.